Key points for using industrial oxygen generators

       Industrial Oxygen GeneratorManufacturers believe that steel enterprises are one of the main consumers of industrial oxygen. Using the combustion-supporting properties of high-purity oxygen, impurities such as carbon, phosphorus, sulfur, and silicon in iron are oxidized, and the heat generated by oxidation can ensure the high temperature required for the steelmaking process. Pure oxygen blowing (greater than 99.2%) greatly shortens the steelmaking time of steel enterprises and improves the quality of steel. Oxygen blowing in electric furnace steelmaking can accelerate the melting of the furnace charge and the oxidation of impurities, saving the enterprise a lot of electricity consumption, and is also a fixed oxygen source for industrial oxygen generators. The application of mechanical oxygen is mainly in metal cutting and welding. Oxygen, as a combustion-supporting agent for acetylene, can produce a high-temperature flame, promoting the rapid melting of metal.

　　High-furnace oxygen-enriched blasting can increase the amount of coal injection, save coke consumption, and reduce the fuel ratio. Although the purity of oxygen-enriched air is only slightly higher than that of air (oxygen content is 24%~25%), the oxygen consumption of large-volume industrial equipment is close to one-third of the steelmaking oxygen, which is also very large. So what should be paid attention to when using an industrial oxygen generator?

　　1.Industrial Oxygen GeneratorAfraid of fire, heat, dust, and moisture. Therefore, when using an oxygen generator, remember to stay away from fire sources and avoid direct glare(Sunlight) and high-temperature environments. Regularly replace and clean the nasal cannula, oxygen supply tube, humidification heating device, etc. Prevent cross-infection and tube blockage; when the oxygen generator is idle for a long time, the power should be cut off, the water in the humidification bottle should be poured out, the surface of the oxygen generator should be wiped clean, the plastic cover should be covered, and it should be stored in a dry place without sunlight; before transporting the machine, the water in the humidification cup should be poured out, and the water or moisture in the oxygen generator will damage important accessories (such as molecular sieves, compressors, pneumatic valves, etc.)。

　　2.When the industrial oxygen generator is running, remember to ensure that the voltage is stable. If the voltage is too high or too low, the instrument will burn out. Therefore, regular manufacturers will be equipped with an intelligent monitoring low-voltage and high-voltage alarm system, and the power base is equipped with a fuse box. For users in remote rural areas, old communities with old lines, or industrially developed areas, it is recommended to purchase a voltage regulator.

　　3. Meets medical standardsIndustrial oxygen generators have24-hour continuous operation technical performance, so they must be used every day. If you go out for a short time, you need to close the flow meter, pour out the water in the humidification cup, cut off the power, and place it in a dry and ventilated place.

　　4.When using an industrial oxygen generator, ensure that the bottom exhaust is smooth, so do not place products that are not easy to dissipate heat and exhaust, such as foam and carpets, underneath, and do not place them in narrow, poorly ventilated places.

　　5.The humidification device of the industrial oxygen generator, commonly known as: humidification bottle, it is recommended to use cold boiled water, distilled water, or pure water as the water in the humidification cup. Try not to use tap water and mineral water to avoid scale formation. The water level should not exceedthe highest scale to prevent it from flowing into the oxygen tube. The humidification bottle interface should be tightened to prevent oxygen leakage.

　　6.The primary and secondary filtration systems of the industrial oxygen generator should be cleaned and replaced regularly.

　　7. If the molecular sieveIndustrial Oxygen Generatoris left idle for a long time, the activity of the molecular sieve will decrease, so attention should be paid to startup, operation, and maintenance.